- 1. Clamshell LG TFT 800x600 - 1024x768 from iBook G4
- (Hardware hints)
- ... is pin-compatible. Use hot glue to fix display in the right position. Apply open firmware hack from http://ibookmod.livejournal.com/ (a little bit tricky) DVD playback on a 466 mhz or 366Mhz (restricted) ...
- 2. Changing the optical drive
- (Hardware hints)
- ... and use even a DVD burner as long as you make sure that it is set to master or cable select. All parts are either screwed and / or glued together. You need a philips screwdriver, a good scraper ...
- 3. Luminiscent Apple Mod
- (Hardware hints)
- ... the mod later on.... If there is some glue left, try to get rid of it. There is a metal shielding behind the display - if you cut a hole in facing the apple you will get a stronger effect, but i don' ...
- 4. Bottom case double-shot in rubber
- (Hardware hints)
- ... iBooks. Afer several years of use the rubber might peel off, you may glue it back using a transparent all-purpose-adhesive. Unfortunately there has never been a spare part by Apple to replace the rubber ...
- 5. 466 SE Indigo "Cybook
- (Hardware hints)
- ... Clear Palmrest (iBook Tangerine) Original Drive Door (modified) The Drive Door- Pretty simple, just cut,the center section gets tossed, then install (i used hotglue). The Only other ...
- 6. My Powerberry 466MHz Firewire Mod
- (Hardware hints)
- ... after looking through my inventory was to replicate a socket from a narrow rounded strip that I cut out of the unused tip of a silicon cartridge and attached with superglue. In terms of ...
- 7. Clamshell Purchase Advisor
- (Hardware hints)
- ... 30-50 euros. - Confirm the displayed battery life under the installed operating system. A new battery is hard to come by. - A functional power supply unit that hasn't been glued or soldered is important. ...